taff
Posts: 4,071
Last Online Apr 6, 2023 15:17:41 GMT
Likes: 3,290
Mar 1, 2017 20:00:42 GMT
|
Post by taff on Apr 14, 2017 14:35:12 GMT
Tried a couple of different builds in this atty, but taste wise, its no-where near as good as my Little 16 for example.
Now i know there are a lot of folk that reckon the Narda is the best flavour atty out there, so what is the best build for these for flavour. Not bothered about low ohms high power vaping, but do you have to build like this to get the best out of it?
|
|
corpus
Full member
Posts: 132
Last Online Jul 30, 2018 19:25:40 GMT
Likes: 170
Mar 24, 2017 18:44:06 GMT
|
Post by corpus on Apr 14, 2017 19:31:04 GMT
hm.. good question. Narda is supposed to be suited to more sensible coils. I had the same problem with the hadaly recently. Not that it was bad, but from all the comments I thought it would be a whole new world of flavour discovery for me. In my case I went with wider diameter coil.. slightly spaced and thicker wire than the usual i use. I don't know how much space you have to play with in the narda to fit a coil but try 3mm diameter if you haven't already .. also keep the coil as low as possible
|
|
Deleted
Deleted Member
Posts: 0
Last Online May 11, 2024 15:48:44 GMT
Likes:
May 11, 2024 15:48:44 GMT
|
Post by Deleted on Apr 14, 2017 21:48:54 GMT
2.5mm ID , 1.3ohms Kanthal 0.3mm Spaced i set the bottom of the coil to the bottom of the air slits i roll 2 wicks, so i can split them at the ends and cut them to just fold / fill the shape at the ends either side the terminal screw seems fine so far for me on a mech squonker , havent used it regulated or as a dripper dripper
|
|