Hands up who didnt buy a Berserker because it was 24mm? ? ?

       Hi I got a mini last Saturday and am quite pleased with it. There are just a couple of points I should mention. 1-- it produces a warm to hot vape depending on your settings and 2 -- when the attie is screwed on your mod it's difficult to change the air flow. I overcame this problem by making a washer which clears the adjusting ring when the attie is screw on the mod. See photo.

No doubt Its the short chimney that gets it hot, a bit of extra length and some liquid cooling would calm it down a bit no doubt.
Damned TPD.

Got one on the way to me from FT.. £20.60 delivered UK post..

I changed my first one from the 2ml tank to the 4, but to be honest at the rate i go through juice on those, a 2ml tank is fine.. its not as if its hard to fill either...

Don't forget guys you can pick this up a 3fvape too ....faster delivery in my book

Thanks for that phtumshk and suzukiv6 I knew those old KF drip tips would have a use someday. I still use mine as a dodgy atempt to counteract a too airy/dtl atty.

Thanks for that mate... also dont like a hot vape...was running my 24 mm one at around the 0.9 mark , and only up to about 16 watts...and that was fine for me..hopefully this one wont be too hot for me then...

I have a doggy style that I run at 1ohm with .3mm wire where my usual is .9 with .4mm wire so hopefully Ill be ok with the short version.

Its when you get your old lady on all 4s then get behin. . . . . . . . . . Oh sh*t wrong forum.
Er hem, Any way its only the cheapest most underrated MTL tank on FT.
Theyve got the SXK versions but I just bought the cheapest to try out and it was pretty awesome.
I used to stick it on my ego-one battery for out and about.
Easy to build/wick and no leaks/condensation ever.
FT_link

My Doggy 's just arrived can anyone link me to a decent review that shows how it's best set up.

Watched this one, not too bad, shows it ok..but no commentary..

Found this on-line:-

Just note there is an important difference between the two available clones at FT (or elsewhere). This SXK has a 1,6mm center air hole, while the SJMY has a 2,3mm one. SXK is much more suitable for real MTL. The SJMY is almost restricted D2L.

Think that there are the non cracking tanks available for this as well mate

I understood that you could only get plastic tanks for this rta and plastic to me means a crackable tank to me, unless someone has found a way to put a glass tank on this rta that is.